Share the Inspiration!
See the tabs below for all products, tools and techniques used to make this piece, plus related Inspiration designs and any additional tips that may be helpful to you!
Attach a clasp to your Regaliz® leather cord design by following these simple steps.
Print these instructions
Regaliz™ Leather Cord
Plastic Straight Cord Cutter
Super New Glue
Make sure to test that all your beads and components fit your cord before you glue anything.
Using the cord cutter, make a flush cut to one end of the Regaliz® leather cord.
Repeat Step 1 on the other end of the cord.
Apply a few drops of Super New Glue into one of the clasp ends. Rotate the piece so that the glue coats the entire interior of the clasp end.
Place the clasp end from Step 3 onto one end of the cord. Hold the clasp end firmly in place for a few seconds while the glue sets.
Slide all of your beads onto the cord.
Repeat Step 3 on the other end of the cord with the second clasp end. Be sure to let your glue dry for 24 hours before you attach both ends of the clasp to each other.
Congratulations! You have completed your Regaliz® leather bracelet!