Share the Inspiration!
See the tabs below for all products, tools and techniques used to make this piece, plus related Inspiration designs and any additional tips that may be helpful to you!
The Magic Finding Pliers are a unique tool for making gorgeous and strong multi-strand jewelry. Follow these easy steps for flawless designs.
5.5 inch Magic Finding Pliers
Mini Stainless Steel Bead Stopper
Read through our Magic Finding FAQ before you begin.
Leave 1/4" of beading wire between your beads and Magic Finding so when you crimp it the strands won't be too tight.
String your beading wire through the center hole of your first Magic Finding. Leave your desired length of beading wire sticking out the far end of the Magic Finding.
Place a bead stopper at the far end of your beading wire right next to the Magic Finding. This will keep your beads and beading wire in the correct spot.
Begin stringing your beads onto the beading wire (on the opposite end of the bead stopper) until you get to your desired length.
After stringing your beads, string the beading wire through a side hole of your second Magic Finding.
String the beading wire back down through another side hole of the Magic Finding. Leave a 1/4" gap between your beads and the Magic Finding.
Pull the beading wire taut until it lays flat against the Magic Finding.
Repeat steps 2-5 until you have your desired amount of strands. You can string between 1-7 strands. Make sure the last strand will go through the center hole of the second Magic Finding.
Once your stinging is completed, place the assembled Magic Finding in the center of the larger hole of the Magic Finding Plier. Crimp the Magic Finding.
Open the tool slightly, rotate the Magic Finding 90 degrees and crimp again.
Repeat steps 8-9 in the large hole of the Magic Finding Pliers three times or until the jaws of the tool can close completely.
Place the Magic Finding in the small hole of the Magic Finding Plier. Crimp the Magic Finding.
Repeat steps 11-12 in the small hole of the Magic Finding Plier three times or until the jaws of the tool can close completely.
Repeat steps 8-13 with the second Magic Finding.
Congratulations! You have now successfully used a Magic Finding with the Magic Finding Plier.