Share the Inspiration!
See the tabs below for all products, tools and techniques used to make this piece, plus related Inspiration designs and any additional tips that may be helpful to you!
Make your own chandelier earring component with Wig Jig pattern 5.
Print these instructions
Centaur Wig Jig
Chain Nose Pliers
Use a thicker gauge wire such as 18 or 20 gauge for a stronger finished wire form.
Harden the wire form to help keep its shape by using either a plastic mallet and bench block or a wire smacker. Refer to the beading technique Hardening a Wire Form.
Place the pegs in the wig jig as shown.
Cut a piece of wire 12 inches long. Place one end of the wire on the left side of the top peg. Bend the wire to a right angle.
Begin wrapping the wire around the top peg.
After wrapping the wire completely around the top peg, bring the wire down around the left peg on the bottom row.
After wrapping the wire completely around the peg, bring the wire down around the next peg to the right.
Repeat steps 5-6 until you reach the last peg on the bottom row.
After wrapping the wire completely around the last peg, bring the wire up around the top peg again.
Wrap the wire around the top peg. This will create a second loop around the top peg.
Take the wire form off of the wig jig. Use your wire cutters to cut off the end of the wire. This will leave a simple loop on one side of the form.
Repeat step 10 on the other side of the wire form.
Using your chain nose pliers, grasp the side of the loop.
Close the loop by moving the open side of the loop back until the loop is closed
Repeat steps 12 and 13 for the other side of the wire form.
Line up the top two loops so they overlap. Make several forms and link them together for a necklace, bracelet or earrings. Also, try hanging beads off of loops.