 |  |
 |  |
 |
 |
Step 1 Pick out a pendant and punch or template. You can also trace around the pendant and cut the image out with scissors. We chose a 22mm round pendant with a 13/16" paper punch. |  | Step 2 Find a paper or image for the pendant. Move the paper punch over the paper until you have found the desired image. |  | Step 3 You now have your desired image ready. |
 |
 |  |
 |  |
 |
 |
Step 4 Apply a thin coat of an adhesive inside the pendant. |  | Step 5 Using a small sponge coat the front of the paper with white craft glue. Let dry. This will prevent the Ice Resin from seeping into the paper. |  | Step 6 Lay the image into the pendant. Press the image into the pendant making sure that all of the edges are laying flat. |
 |
 |  |
 |  |
 |
 |
Step 7 Let the glue set for a few minutes. |  | Step 8 If there are items with holes such as beads, it is a good idea to fill the holes with glue to prevent any bubbles from occurring once the Ice Resin is poured. |  | Step 9 Add drops of adhesive to the paper where you are going to place the beads. |
 |
 |  |
 |  |
 |
 |
Step 10 Using Tweezers gently place any beads or charms onto the adhesive into the pendant. Let dry completely. |  | Step 11 Always measure the resin and hardener in equal amounts. With a permanent marker mark your measuring cup so the measurements you are using are easier to see. We have made our first mark at 1/4 fl. oz. |  | Step 12 With a permanent marker make your second mark. The two measurments should now be of equal amounts. We have made our second mark at 1/2 fl. oz. |
 |
 |  |
 |  |
 |
 |
Step 13 Make sure the cup is resting on an even surface and pour the resin (part A) into the measuring cup filling it until the first marked line. We are filling it until the 1/4 fl. oz. marked line. At first the resin (part A) has a slight blue tint to it. |  | Step 14 Pour the hardener (part B) into the measuring cup filling it until the second marked line. We are filling it until the 1/2 fl. oz. marked line. At first the hardener (part B) has a slight yellow tint to it. |  | Step 15 Using a stir stick mix the resin and hardener together by folding very gently to avoid any bubbles. |
 |
 |  |
 |  |
 |
 |
Step 16 Continue mixing, making sure you scrape the sides of the measuring cup so the resin and hardener get competely mixed together. Mix for a minimum of two minutes. Once the resin is done it should look clear. |  | Step 17 Begin to fill the pendant with Ice Resin. |  | Step 18 Slowly begin to pour ICE Resin in the collage pendant. If you would like to dome your piece fill the bezel 3/4 of the way full otherwise pour your ICE Resin to the top of the collage pendant. |
 |
 |  | |  | |
 |
Step 19 Congratulations! You have created a unique ICE Resin piece to use in your jewelry designs. |  |
|  |
|
 |