 |  |
 | |
 |
|
Step 1
String a bead or beads onto a head pin. | | Step 2
Cut the head pin, leaving 3/8". | | Step 3
Bend the wire at the top of the bead to a 90° angle with chain nose pliers or your fingers. |
|
 | |
 | |
 |
|
Step 4
Grasp the end of the wire with round nose pliers so the wire is flush with the tool. | | Step 5
Rotate the pliers to form a loop. | | Step 6
Continue turning the wire until a complete loop is formed. |
|
 | |
 | |
 |
|
Step 7
To open the loop, grasp the side of the loop closest to the opening with chain nose pliers and move this side of the loop toward you. | | Step 8
Attach the loop to your desired location. To close the loop, grasp the open side with chain nose pliers and move away from you until the loop is closed and the end of the wire is flush with the base of the loop. | | Tip:
To make a smaller loop, work closer to the tip of the round nose pliers. |
|
 | | | | |
|
Tip:
If you want to make a larger loop, start with a piece of wire longer than 3/8" and make the loop further back from the tip of the round nose pliers.
| |
| |
|
|
