
Messy Wire Wrapped Link
A messy wire wrapped link is just like it sounds: messy! You don't need to worry about the wires laying perfectly next to each other, the point is to wrap in a free form organic fashion.
Print this Technique
Bead(s) with a center drilled hole
Wire - 24 gauge Sterling Silver Dead Soft shown

Step 1
Grasp your wire about 3"" down from the top with your chain nose pliers.

Step 2
With your finger, push the wire to a 90° angle.

Step 3
Using your round nose pliers, grasp the wire right at the bend.

Step 4
Pull the wire around the round nose pliers until it is almost pointing directly down.

Step 5
Reposition your pliers by opening your round nose pliers (but do not pull the pliers out of the loop) and pivot your pliers so the bottom tip is on the top. Continue pulling the wire around the nose of the pliers until the loop is completely round.

Step 6
Attach a link or chain into the loop.

Step 7
To then wrap the loop, grip the loop with the chain nose pliers and grip the wire with your fingers.

Step 8
Wrap the short wire around the long wire in a free form fashion.

Step 9
Using the wire cutters, cut off the extra wire as close as you can to the wrap.

Step 10
Tuck the remaining tip of wire with your chain nose pliers so there are no sharp pieces of wire sticking out that can snag on clothing.

Step 11
Slide a bead or beads on the wire.

Step 12
Using the tips of your chain nose pliers, grab the wire directly above the beads.

Step 13
With your finger, push the wire to a 90° angle.

Step 14
Using your round nose pliers, grasp the wire right at the bend.

Step 15
Pull the wire around the round nose pliers until it is almost pointing directly down. Reposition your pliers by opening your round nose pliers (but do not pull the pliers out of the loop) and pivot your pliers so the bottom tip is on the top. Continue pulling the wire around the nose of the pliers until the loop is completely round.

Step 16
Attach a link or chain into the loop.

Step 17
To then wrap the loop, grip the loop with the chain nose pliers and grip the wire with your fingers.

Step 18
Wrap the wire around the base wire in a free form fashion. Continue wrapping the wire down to the bead.

Step 19
Using the wire cutters, cut off the extra wire as close as you can to the beads.

Step 20
Tuck the remaining tip of wire with your chain nose pliers so there are no sharp pieces of wire sticking out that can snag on clothing.

Step 21
Congratulation! You now have a messy wire wrapped link.
- Home
- Messy Wire Wrapped Link | Beading Techniques | Fusion Beads