For this technique we will be using the Rose Pin Die Set with a Rose Pin.
Hold the Crystal Applicator Tool So the spring end is up.
Place the lower die in the bottom of the Crystal Applicator Tool. Turn the scew until the lower die is secure.
Place the adaptor into the top of the Crystal Applicator Tool. Screw the adaptor until it is secure.
Place the adhesive disc that's included with your set (sticky side down) into the upper die. Push it down to the bottom of the upper die with the pin. This will help to hold the rose pin in place (step 9).
Place the upper die over the adapter. (we are using the SS34 upper die)
Place the thumbscrew through the hole of the upper die. Turn the screw until the upper die is secure.
The rose pin will go right side up when placed into the upper die.
Place the rose pin into the upper die. The adhesive disc that was inserted in step 5 will help to hold the rose pin in place.
Place the material you want your rose pin to go through along the bottom of your Crystal Applicator Tool. Press down firmly to secure your rose pin. (We are using a 10mm strip of deertan lace).
Congratulations! You have successfully used the Crystal Applicator Tool to add a rose pin.
- Using the Crystal Applicator Tool with Rose Pins